2010 Chevrolet Equinox Owner's Manual - Page 315
2010 Chevrolet Equinox Manual
Page 315 highlights
Vehicle Care 6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install into lamp assembly. 7. Turn the lamp assembly into the liftgate engaging the clip side first. 8. Push on the lamp side opposite the clip until the lamp assembly snaps into place. 9-37 Replacement Bulbs Exterior Lamp Back-Up Lamp Fog Lamp Front Headlamp High Beam Headlamp Low Beam License Plate Lamp Parking Lamp/Turn Signal Front Sidemarker Front and Rear Taillamp/Turn Signal Lamp/Stop Lamp Bulb Number 921 H11 HB3 H11 W5WLL T20 194 3157K Electrical System Fuses The wiring circuits in the vehicle are protected from short circuits by fuses. This greatly reduces the chance of damage caused by electrical problems. Look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Be sure to replace a bad fuse with a new one of the identical size and rating. There are two fuse blocks in the vehicle: one in the engine compartment and one in the instrument panel. There is a fuse puller located in the engine compartment fuse block. See Engine Compartment Fuse Block on page 9‑38. It can be used to easily remove fuses from the fuse block. For replacement bulbs not listed here, contact your dealer/retailer.