2010 Chevrolet Equinox Owner's Manual - Page 262
2010 Chevrolet Equinox Manual
Page 262 highlights
8-48 Driving and Operating When the System Does Not Seem to Work Properly If the URPA system does not activate due to a temporary condition, the message Park Assist Off displays on the DIC and a red light is shown on the rear URPA display when the shift lever is moved into R (Reverse). This can occur under the following conditions: . The following describes how the URPA display lights appear as the vehicle gets closer to a detected object: Description amber light amber/amber lights amber/amber/red lights and continuous beeping for five seconds amber/amber/red lights flashing and continuous beeping for five seconds Metric 2.5 m 1.0 m 0.6 m English 8 ft 40 in 23 in 0.3 m 1 ft Park Assist Off displays on the Driver Information Center (DIC) to indicate that URPA is off, see Driver Information Center (DIC) on page 4‑27 for more information. The settings are: ... On: Turns URPA on Off: Turns URPA off Tow Bar: Use when a tow bar is attached to the vehicle . The ultrasonic sensors are not clean. Keep the vehicle's rear bumper free of mud, dirt, snow, ice and slush. For cleaning instructions, see Exterior Care on page 9‑81. A trailer was attached to the vehicle, or an object was hanging out of the liftgate during the last drive cycle, a red light may come on in the rear display. Once the attached object is removed, URPA will return to normal operation. System Settings Each time the vehicle is started URPA defaults to the On setting. Use the Vehicle Personalization on page 4‑39 menu to configure URPA. Tow Bar When the tow bar setting is used, an area of 16 cm (6 in) around the hitch is not detected by the system.