2005 Chrysler Crossfire Owner's Manual - Page 105
2005 Chrysler Crossfire Manual
Page 105 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 105 If the charging system indicator light comes on, or a loss of power steering assistance is noticeable while the engine is running, this may indicate that the accessory drive belt has broken. Should this condition occur, the belt must be replaced before continuing to operate the vehicle. 17. Electronic Digital Clock A digital readout in the instrument cluster shows the time in hours and minutes whenever the ignition switch is in the ON/RUN or ACC position. When the ignition switch is in the OFF/LOCK position, timekeeping is accurately maintained. The display can be adjusted with the knob/button located to the left of the clock. 18. Gear Indicator For automatic transmission vehicles, the current gear shift selector range is indicated in the gear range indicator display. 19. Push Button for Time Setting To adjust the time display, turn the key in the ignition switch to the ON/RUN or ACC position. The knob/ button located just to the left of the clock is used to change the time. Pull out the knob and turn it to the left for hour adjustment; pull out the knob and turn it to the right for minute adjustment. CAUTION! The accessory drive belt also drives the water pump. Operating the vehicle with a failed belt can cause engine overheating and possible severe engine damage. 16. High Beam Indicator Light This indicator will illuminate when the headlights are in the high beam setting. 4 To activate the high beams, push the multifunction control lever past the point of resistance, toward the instrument panel.