2007 Chrysler 300 Owner Manual SRT8 - Page 260

260 WHAT TO DO IN EMERGENCIES 5. Unscrew the valve cap from the valve on the deflated tire. 6. Screw the fitting at the end of TIREFIT sealant hose (6) coming from the sealant bottle (5) onto the tire valve. 7. Insert the power plug (2) into the power point on the instrument panel. 8. Leave the parking brake set and the transmission selector lever in PARK and start the engine. 9. Press the switch (3) on the air pump to I (ON). The air pump should start to inflate the tire and the tire sealant (white fluid) will flow from the sealant bottle (5) through the TIREFIT sealant hose (6) and into the tire. 10. Allow the air pump to run for five minutes and then read the pressure gauge (4). If the tire inflates to 26 psi (1.8 bar) or greater, proceed to Step 19 of this procedure. If not, proceed to the following step. 11. Press the air pump switch (3) to 0 (OFF). Then, disconnect the TIREFIT system from the tire and place it back in the vehicle. 12. Release the parking brake and drive the vehicle back and forth approximately 30 feet (9.1 m) to distribute the sealant more evenly within the tire. 13. Turn on the hazard warning flashers. 14. Move the transmission selector lever to the PARK position, turn off the engine, and set the parking brake. 15. Disconnect the air pump hose (1) from the underside of the sealant bottle (5) by flipping the hose valve open. 16. Connect the air pump hose valve to the tire valve and flip the hose valve closed. 17. Leave the parking brake set and the transmission selector lever in PARK and start the engine. 18. Press the switch (3) on the air pump to I (ON). The air pump should inflate the tire to at least 26 psi (1.8 bar) within five minutes. If the tire inflates to this level, proceed to the following step. NOTE: If a tire pressure of 26 psi (1.8 bar) is not obtained within five minutes, the tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance.