2007 Chrysler 300 Owner Manual SRT8 - Page 97
2007 Chrysler 300 Manual
Page 97 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 97 3. Push the Multi-Function Lever away from you to switch the headlights to the HIGH BEAM position. NOTE: This system will not activate until the vehicle is at or above 25 mph (40 km/h). To Deactivate: Perform either of the following steps to deactivate the SmartBeam system. 1. Pull the Multi-Function Lever toward you to switch the headlights from the HIGH BEAM to the LOW BEAM position. 2. Rotate the headlight switch clockwise from the AUTO (A) to the ON position. NOTE: Broken, muddy, or obstructed headlights and taillights of vehicles in the field of view will cause headlights to remain on longer (closer to the vehicle). Also, dirt, film, and other obstructions on the windshield or camera lens will cause the system to function improperly. Headlight Time Delay This feature provides the safety of headlight illumination for 90 seconds (programmable) when leaving your vehicle in an unlighted area. To activate the delay feature, turn off the ignition switch while the headlights are still on. Then, turn off the headlights within 45 seconds. The delay interval begins when headlight switch is turned off. If you turn the headlights, park lights, or ignition switch on again, the system will cancel the delay. If you turn the headlights off before the ignition, they will turn off in the normal manner. NOTE: The lights must be turned off within 45 seconds of turning the ignition off to activate this feature The Headlight delay time is programmable. For details, refer to "Delay Turning Headlights Off," under "Personal Settings (Customer Programmable Features)," under "Electronic Vehicle Information Center (EVIC)" in Section 4 of this manual. 3