2008 Chrysler Town & Country Owner Manual - Page 158
2008 Chrysler Town & Country Manual
Page 158 highlights
156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Disable A RKE Transmitter Linked to Memory 1. Turn the ignition switch to the OFF position and remove the key. 2. Press and release Memory Button 1. The system will recall any memory settings stored in position 1. Wait for the system to complete the memory recall before continuing to step 3. 3. Press and release the memory SET(S) button located on the driver's door. A chime will sound signaling that you are in the memory set mode. 4. Within five seconds, press and release Memory Button 1 on the driver's door. A chime will sound signaling to you that the driver memory has been set. 5. Within five seconds, press and release the UNLOCK button on the Remote Keyless Entry transmitter. A chime will sound signaling to you that the transmitter link has been successfully disabled. To disable another transmitter linked to either Memory Position, repeat steps 1 to 5 for each transmitter. NOTE: Once programmed, all transmitters linked to memory can be easily enabled or disabled at one time. Refer to the Remote Linked to Memory ЉCustomer Programmable FeaturesЉ in the Electronic Vehicle Information Center (EVIC) for more information. TO OPEN AND CLOSE THE HOOD To open the hood, two latches must be released. 1. Pull the hood release lever located on the instrument panel, below the steering column. 2. Move to the front of the vehicle and look inside the center of the hood opening. Locate then push the safety catch lever to the right while raising the hood at the same time.