2008 Chrysler Town & Country Owner Manual - Page 37

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 35 The Unlock Doors Automatically On Exit feature can be enabled or disabled by performing the following procedure: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt. (Fastening the seat belt will cancel any chimes that may be confusing during this programming procedure.) 3. Insert the key into the ignition switch. 4. Within 15 seconds, cycle the ignition key from the OFF position to the ON/RUN position a minimum of four times ending in the OFF position (Do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the unlock direction. 6. A single chime will sound to indicate the feature has been changed. 7. To reactivate this feature, repeat the above steps. If a chime is not heard, the program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. The Unlock Doors Automatically On Exit feature can be reactivated by repeating the above mentioned procedure or by performing the procedure in the EVIC, Customer Programmable Features section on vehicles so equipped. NOTE: Use the Lock Doors Automatically at 15 mph (24 km/h) and Unlock Doors Automatically On Exit features in accordance with local laws. 2