2009 Dodge Ram 1500 Pickup Owner Manual - Page 178

176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) NOTE: Some gate operators and garage door openers from the HomeLink௡ buttons while keeping the EVIC may require you to replace Step 3 with procedures noted display in view. in the "Gate Operator/Canadian Programming" section. For optimal training, point the battery end of the hand- 4. Press and hold the just-trained HomeLink௡ button. If held transmitter away from the HomeLink௡ the channel has been trained, the EVIC display will now state "CHANNEL # TRANSMIT". 3. Simultaneously press and hold both the chosen HomeLink௡ button and the hand-held transmitter button If the EVIC display still states "CHANNEL # TRAINuntil the EVIC display changes from "CHANNEL # ING" repeat Step 3. TRAINING" to "CHANNEL # TRAINED". NOTE: After training a HomeLink௡ channel, if the Then release both the HomeLink௡ and hand-held trans- garage door does not operate with HomeLink௡ and the mitter buttons. garage door opener was manufactured after 1995, the garage door opener may have rolling code. If so, proceed If the EVIC display states "DID NOT TRAIN" repeat to the heading "Programming A Rolling Code System." step 3. If the signal is too weak, replace the battery in the original hand-held transmitter. 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate It may take up to 30 seconds, or longer, in rare cases. The the "learn" or "training" button. garage door may open and close while you train.