2009 Dodge Ram 1500 Pickup Owner Manual - Page 181

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 179 The HomeLink௡ Universal Transceiver is disabled when Reprogramming A Single HomeLinkா Button To reprogram a channel that has been previously trained, the Vehicle Security Alarm is active. follow these steps: Troubleshooting Tips If you are having trouble programming HomeLink௡, here 1. Turn the ignition switch to the ON/RUN position. are some of the most common solutions: 2. Press and hold the desired HomeLink௡ button for 20 seconds until the EVIC display states "CHANNEL # • Replace the battery in the original transmitter. TRAINING." Do not release the button. • Press the learn button on the garage door opener to complete the training for rolling code. 3. Without releasing the button, proceed with Programming HomeLink௡ Step 2 and follow all remaining steps. • Did you unplug the device for training, and remember Security to plug it back in? It is advised to erase all channels before you sell or turn If you are having any problems or require assistance, in your vehicle. please call toll-free 1-800-355-3515 or, on the Internet at To do this, press and hold the two outside buttons for www.HomeLink.com for information or assistance. 20 seconds until the EVIC message states "CHANNELS CLEARED." Note that all channels will be erased. Individual channels cannot be erased. 3