2012 Ford F150 Owner Guide 2nd Printing - Page 119

Driver Controls For questions or comments, contact HomeLink௡ at www.homelink.com or 1-800-355-3515. Programming HomeLinkா to a Genie Intellicodeா 2 garage door opener Note: The Genie Intellicode 2௡ transmitter must already be programmed to operate with the garage door opener. Programing the transmitters To program HomeLink௡ to the transmitter you must first put the transmitter into programming mode. To do this A. Red LED B. Green LED A B 1. Press and hold one of the buttons on the transmitter for 10 seconds. The LED light will change from green to green and red. 2. Press the same button twice to confirm the change to Programming mode. If done properly the LED light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 cm) of the HomeLink௡ button. 4. Press and hold the both the programmed Genie button and the HomeLink௡ button you want to program. The HomeLink௡ LED will flash rapidly when the programming is successful. Note: the Genie transmitter will transmit for up to 30 seconds. If HomeLink௡ does not program within 30 seconds the Genie transmitter will need to be pressed again. If the Genie transmitter LED displays green and red, release the button until the LED turns off before pressing the button again. 119 2012 F-150 (f12) Owners Guide, 2nd Printing USA (fus)