2012 Ford F150 Owner Guide 2nd Printing - Page 120

Driver Controls Once HomeLink௡ has been programmed successfully, the Genie transmitter must be changed out of program mode. To do this: 1. Press and hold the previously programmed Genie button for 10 seconds. The LED will change from red to red and green. 2. Press the same button twice to confirm the change. If done correctly the LED will turn green. Programming HomeLinkா to the Genie Intellicodeா garage door opener motor Note: You may need a ladder to access the garage door opener motor. To program HomeLink௡ to the garage door opener motor. 1. Press and hold the PROGRAM button on the Garage door opener motor until both blue LED's turn on. 2. Release the PROGRAM button. Only the smaller round LED should be on. 3. Press and release the program button. The larger purple LED will flash Note: The next two steps must be completed in 30 seconds. 4. Press and release the Genie Intellicode௡ 2 transmitter's previously programmed button. Both LED's on the garage door opener motor unit should now flash purple. 5. Press and hold the previously programmed HomeLink௡ button for two seconds. Repeat this step up to three times until the garage door moves. At this point programming is complete. Clearing a HomeLinkா device To erase programming from the three HomeLink௡ buttons press and hold the two outer HomeLink௡ buttons until the indicator light begins to flash. The led will begin flashing in 10 to 20 seconds, at which time both buttons should be released. Programming has now been erased, and the led should blink slowly to indicate the device is in train mode when any of the three HomeLink buttons are pressed. 120 2012 F-150 (f12) Owners Guide, 2nd Printing USA (fus)