2015 Ford Flex Owner Manual Printing 1 - Page 318

Maintenance 317 Replacing front parking lamp/turn signal bulbs 1. Make sure headlamp switch is in the off position, then open the hood. 2. Reach behind the headlamp assembly to access the bulb sockets . 3. Remove the bulb socket by turning it counterclockwise and pulling it straight out. 4. To remove the bulb, pull it straight out of the bulb socket. Install the new bulb(s) in reverse order. Replacing fog lamp bulbs 1. Make sure the fog lamp switch is in the off position. 2. From underneath the vehicle, partially remove the tire splash shield by removing four drive screws from the lower flap. The splash shield flap can now be repositioned to allow access to the front fog lamp bulb and electrical wire harness. 3. Carefully disconnect the wire harness connector from the bulb by releasing the two snap clips. 4. Rotate the bulb counterclockwise to remove from the fog lamp. Install the new bulb in reverse order. 2015 Flex (471) Owners Guide gf, 1st Printing, October 2014 USA (fus)