2015 Ford Flex Owner Manual Printing 1 - Page 85

84 Locks Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • switching the ignition on • unlocking the vehicle using intelligent access. Unlocking and Locking the Doors To unlock the driver door: Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if the two-stage unlocking feature is disabled. Refer to Locking and Unlocking earlier in this chapter. To unlock all doors: Enter the factory-set code or your personal code, then press 3•4 within five seconds. To lock all doors: Press and hold 7•8 and 9•0 at the same time with the driver door closed. You do not need to enter the keypad code first. Displaying the Factory-Set Code with Integrated Keyhead Transmitters Note: You will need to have two programmed Integrated Keyhead Transmitters for this procedure. To display the factory-set code in the information display: 1. Place the first programmed key in the ignition. 2. Turn the ignition off and remove the first programmed key. 3. Place the second programmed key in the ignition. You will see the factory-set code in the message center. The code appears for a few seconds. Note: The code may not display until after any other warning messages first display. 2015 Flex (471) Owners Guide gf, 1st Printing, October 2014 USA (fus)