2015 Ford Fusion Owner Manual Printing 1 - Page 230
2015 Ford Fusion Manual
Page 230 highlights
Roadside Emergencies Jump Starting 1. Start the engine of the booster vehicle and rev the engine moderately, or press the accelerator gently to keep your engine speed between 2000 and 3000 rpms, as shown in your tachometer. 2. Start the engine of the disabled vehicle. 3. Once the disabled vehicle has been started, run both vehicle engines for an additional three minutes before disconnecting the jumper cables. 2. Remove the jumper cable on the negative (-) terminal of the booster vehicle's battery. 3. Remove the jumper cable from the positive (+) terminal of the booster vehicle's battery. 4. Remove the jumper cable from the positive (+) terminal of the disabled vehicle's battery. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the battery can recharge. Removing the Jumper Cables Remove the jumper cables in the reverse order that they were connected. POST-CRASH ALERT SYSTEM The system flashes the turn signal lamps and sounds the horn (intermittently) in the event of a serious impact that deploys an airbag (front, side, side curtain or Safety Canopy) or the safety belt pretensioners. The horn and lamps will turn off when: • The hazard control button is pressed • The panic button (if equipped) is pressed on the remote entry transmitter • Your vehicle runs out of power 4 2 1 SPINOUT DETECTION If your vehicle detects a spinout and it comes to a stop, the hazard warning flashers turn on. A spinout detected message appears in the information display. The message may not appear if your vehicle runs out of power. After your vehicle's hazard warning flashers turn on, you can switch them off by: • Pressing the hazard warning flasher button. • Pressing the remote control unlock button. 3 E142665 1. Remove the jumper cable from the ground metal surface or connecting point, if available. 227 Fusion/Mondeo (CC7), enUSA