2015 Ford Fusion Owner Manual Printing 1 - Page 285

Wheels and Tires pressure gauge reading will indicate the tire inflation pressure after about 30 seconds of operation. The final tire pressure should be checked with the compressor turned OFF in order to get an accurate pressure reading. Note: If you experience any unusual vibration, ride disturbance or noise while driving, reduce your speed until you can safely pull off to the side of the road to call for roadside assistance. Note: Do not proceed to the second stage of this operation. Second Stage: Checking Tire Pressure WARNINGS If you are proceeding from the First Stage: Re-inflating the Tire with Sealing Compound and Air section and have injected sealant in the tire and the pressure is below 20 psi (1.4 bar), continue to the next step. The power plug may get hot after use and should be handled carefully while unplugging. Check the air pressure of your tires as follows: E175982 9. When the recommended tire pressure is reached, turn off the kit, unplug the power cable, and disconnect the hose from the tire valve. Re-install the valve cap on the tire valve and return the kit to the stowage area. 10. Immediately and cautiously, drive the vehicle 4 miles (6 kilometers) to distribute the sealant evenly inside the tire. Do not exceed 50 mph (80 km/h). 11. After 4 miles (6 kilometers), stop and check the tire pressure. See Second stage: Checking tire pressure. E175983 1. Remove the valve cap from the tire valve. 2. Firmly screw the air compressor hose onto the valve stem by turning clockwise. 3. Push and turn the dial clockwise to the air position. 282 Fusion/Mondeo (CC7), enUSA