2010 Jeep Grand Cherokee Owner Manual SRT8 - Page 118

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 117 WARNING! Leaving the Electronic Speed Control System on when not in use is dangerous. You could accidentally set the system or cause it to go faster than you want. You could lose control and have an accident. Always leave the system OFF when you are not using it. To Set a Desired Speed When the vehicle has reached the desired speed, press down on the lever and release. Release the accelerator and the vehicle will operate at the selected speed. the set speed memory. Pressing the ON/OFF button or turning off the ignition switch erases the set speed memory. To Resume Speed To resume a previously set speed, push the RESUME ACCEL lever up and release. Resume can be used at any speed above 25 mph (40 km/h). 3 To Vary the Speed Setting When the Electronic Speed Control is set, you can increase speed by pushing up and holding the RESUME ACCEL lever. If the lever is continually held in the RESUME ACCEL position, the set speed will continue to NOTE: The vehicle should be traveling at a steady increase until the lever is released, then the new set speed speed and on level ground before pressing the SET lever. will be established. To Deactivate Tapping RESUME ACCEL once will result in a 1 mph A soft tap on the brake pedal, pulling the lever toward (2 km/h) speed increase. Each time the lever is tapped you, or normal brake pressure while slowing the vehicle the vehicle speed increases, so that tapping the lever will deactivate Electronic Speed Control without erasing three times will increase speed by 3 mph (5 km/h).