2010 Jeep Grand Cherokee Owner Manual SRT8 - Page 131

130 UNDERSTANDING THE FEATURES OF YOUR VEHICLE HomeLink௡ for more efficient training and accurate If the EVIC display states "DID NOT TRAIN" repeat transmission of the radio-frequency signal. Step 3. If the signal is too weak, replace the battery in the handheld transmitter. Your vehicle should be parked outside of the garage It may take up to 30 seconds or longer in rare cases. The while training. garage door may open and close while you train. 1. Turn the ignition switch to the ON/RUN position. NOTE: Some gate operators and garage door openers 2. Place the handheld transmitter 1 to 3 in (3 to 8 cm) may require you to replace Step 3 with procedures noted from the HomeLink௡ buttons while keeping the EVIC in the "Gate Operator/Canadian Programming" section. display in view. 4. Press and hold the just-trained HomeLink௡ button. If For optimal training, point the battery end of the handthe channel has been trained, the EVIC display will now held transmitter away from the HomeLink௡. state "CHANNEL # TRANSMIT." 3. Simultaneously, press and hold both the chosen If the EVIC display still states "CHANNEL # TRAINHomeLink௡ button and the handheld transmitter button ING" repeat Step 3. until the EVIC display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." Then release both the HomeLink௡ and handheld transmitter buttons.