2010 Jeep Grand Cherokee Owner Manual SRT8 - Page 98

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 97 2. Press and release MEMORY button number 1. The system will recall any memory settings stored in position 1. Wait for the system to complete the memory recall before continuing to Step 3. Easy Entry/Exit Seat This feature provides automatic driver's seat positioning which will enhance driver mobility out of and into the vehicle. 3. Press and release the memory S (SET) button located There are two possible Easy Entry/Exit adjustments on the driver's door. available: 4. Within five seconds, press and release MEMORY • The seat cushion will move rearward approximately button 1 on the driver's door. 2.5 in (60 mm), if the starting position of the seat is greater than or equal to 2.67 in (68 mm) forward of the 5. Within five seconds, press and release the UNLOCK rear seat stop when the key is removed from the button on the RKE transmitter. ignition switch. The seat will then move forward To disable another RKE transmitter linked to either approximately 2.5 in (60 mm) when the key is placed memory position, repeat steps 1 through 5 for each RKE into the ignition and turned out of the LOCK position. transmitter. NOTE: Once programmed, all RKE transmitters linked • The seat will move to the position located 0.3 in (8 mm) forward of the rear stop if the starting position to memory can be easily enabled or disabled at one time. is between 0.9 to 2.67 in (23 to 68 mm) forward of the Refer to "Electronic Vehicle Information Center (EVIC)/ rear stop when the key is removed from the ignition Customer-Programmable Features" in "Understanding switch. The seat will move forward to the memory/ Your Instrument Panel" for further information. 3