2010 Jeep Grand Cherokee Owner Manual SRT8 - Page 134

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 133 Then proceed with Step 4 under "Programming 3. Without releasing the button, proceed with Programming HomeLink௡ Step 2 and follow all remaining steps. HomeLink௡" earlier in this section. Using HomeLinkா To operate, press and release the programmed HomeLink௡ button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The handheld transmitter of the device may also be used at any time. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the EVIC message states "CHANNELS CLEARED." Note that all channels will be erased. Individual channels cannot be erased. 3 Reprogramming A Single HomeLinkா Button The HomeLink௡ Universal Transceiver is disabled when To reprogram a channel that has been previously trained, the Vehicle Security Alarm is active. follow these steps: Troubleshooting Tips 1. Turn the ignition switch to the ON/RUN position. If you are having trouble programming HomeLink௡, here 2. Press and hold the desired HomeLink௡ button for are some of the most common solutions: 20 seconds until the EVIC display states "CHANNEL # • Replace the battery in the original transmitter. TRAINING." Do not release the button.