2010 Jeep Grand Cherokee Owner Manual SRT8 - Page 64

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 63 belt tight; however, any seat belt system will loosen • If the belt still cannot be tightened, or if pulling and with time, so check the belt occasionally and pull it pushing on the restraint loosens the belt, disconnect tight if necessary). For the second row center seat belt the latch plate from the buckle, turn the buckle with the automatic locking retractor, pull the belt from around, and insert the latch plate into the buckle the retractor until there is enough allowance to pass it again. If you still cannot make the child restraint through the child restraint and slide the latch plate secure, try a different seating position. into the buckle. Then, pull the belt until it is fully • Buckle the child into the restraint exactly as the extended from the retractor. Allow the belt to return manufacturer's instructions tell you. into the retractor, pulling on the excess webbing to tighten the lap portion around the child restraint. For • When your child restraint is not in use, secure it in the vehicle with the seat belt or remove it from the vehicle. additional information, refer to ЉAutomatic Locking Do not leave it loose in the vehicle. In a sudden stop or ModeЉ. collision, it could strike the occupants or seatbacks and • In the rear seat, you may have trouble tightening the cause serious personal injury. lap/shoulder belt on the child restraint because the buckle or latch plate is too close to the belt path NOTE: For additional information, refer to opening on the restraint. Disconnect the latch plate www.seatcheck.org or call 1-866-SEATCHECK. from the buckle and twist the short buckle-end belt Canadian residents, should refer to Transport several times to shorten it. Insert the latch plate into Canada's website for additional information. http://www.tc.gc.ca/roadsafety/safedrivers/childsafety/index.htm the buckle with the release button facing out. 2