1996 Lincoln Continental Owner's Manual - Page 282

2. Slip the bulb retaining ring over the plastic base until it contacts the rear of the socket. Lock the ring into the socket by rotating it clockwise until you feel a "stop". 3. Push the electrical connector into the rear of the plastic base until it snaps, locking it into position 4. Carefully position the headlamp assembly onto the vehicle making sure the alignment pins are inserted into the proper holes 5. Hold the headlamp assembly snugly against the vehicle and push down on the right angle brackets to lock the lamp into position. 6. Install the plastic sight shield. 7. Turn the headlamps on and make sure that they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again.. Aiming Headlamps Your vehicle is equipped with a Vehicle Headlamp Aim Device (VHAD) on each headlamp body. Each headlamp may be properly aimed in the horizontal direction (left/right) and the vertical position (up/down). NOTE: A non-zero bubble reading does not necessarily indicate out-of-aim headlamps. If your vehicle is not positioned on a level surface, the slope will be included in the level indicator. Therefore, vertical headlamp adjustment should be Tools required: One 4mm socket and ratchet. The Horizontal aim must be adjusted first. 280