2013 Lincoln Navigator Owner Manual Printing 1 - Page 178

178 Universal Garage Door Opener (If Equipped) Reprogramming a single button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink௡ at www.homelink.com or 1-800-355-3515. Programming HomeLinkா to a Genie Intellicodeா 2 garage door opener Note: The Genie Intellicode௡ 2 transmitter must already be programmed to operate with the garage door opener. Programing the transmitters To program HomeLink௡ to the transmitter you must first put the transmitter into programming mode. To do this A. Red LED B. Green LED A B 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The LED light will change from green to green and red. 2. Press the same button twice to confirm the change to Programming mode. If done properly the LED light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 centimeters) of the button on the sun visor you want to program. 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button on the sun visor you want to program. The indicator light on the sun visor will flash rapidly when the programming is successful. 2013 Navigator (nav) Owners Guide gf, 1st Printing USA (fus)