2013 Lincoln Navigator Owner Manual Printing 1 - Page 59

MyKey 59 • Audio system maximum volume of 45%. A message in the audio system is displayed when attempting to exceed the limited volume. • AdvanceTrac. The system cannot be turned off when Always-on has been set. CREATING A MYKEY Use the information display controls to create a MyKey. 1. Insert the key you want to program into the ignition or, if the vehicle is equipped with push button start, put the Intelligent Access key in the backup slot; see the Starting and Stopping the Engine chapter for the backup slot location. 2. Turn the ignition on. 3. Press SETUP using the information display buttons until PRESS RESET TO CREATE MYKEY is displayed. 4. Press and release the RESET button. HOLD RESET TO CONFIRM MYKEY will be displayed. 5. Press and hold the RESET button for two seconds until MARK THIS AS RESTRICTED is displayed Wait until KEY RESTRICTED AT NEXT START is displayed. The key is successfully programmed. Make sure you label it so you can distinguish it from the admin keys. To program optional settings for the key(s), see the Programming/Changing Optional Settings chapter. Programming/Changing Optional Settings Note: All programmed keys can be cleared within the same key cycle in which a key was programmed, otherwise an admin key is required to clear the keys. To clear all keys, see Clearing all MyKeys. You can access the optional settings through the information display controls. 1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed. 2. Press and release the RESET button to display MyKey setup menus. 3. Press the SETUP button to display the next menu to scroll through your choices. 4. On any of the menus, press RESET to highlight your choice with the . 5. Press SETUP to enter your choice. The next optional setting will be displayed. 6. Repeat Steps 4 and 5 until you are done changing the optional settings. 2013 Navigator (nav) Owners Guide gf, 1st Printing USA (fus)