2013 Lincoln Navigator Owner Manual Printing 1 - Page 73

Locks Tips: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. 73 • The factory set code will work even if you have set your own personal code. Programming Memory to a Personal Entry Code To program a personal entry code to recall a driver memory setting, repeat Steps 1-4 above. • Pressing 1•2 on the keypad in Step 4 will program the code to driver memory setting 1. • Pressing 3•4 in Step 4 will program the code to driver memory setting 2. Note: Pressing 5•6, 7•8, or 9•0 keypad numbers in Step 4 will not program the code to recall a driver memory setting. Note: The factory-set code cannot be associated with a memory setting. Erasing Personal Code 1. Enter the factory set 5-digit code. 2. Press and release the 1•2 on the keypad within five seconds. The doors will lock and then unlock to confirm that the system is in programming mode. 3. Press and hold the 1•2 for two seconds. This must be done within five seconds of completing Step 2. All personal codes are now erased and only the factory set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if the wrong code has been entered seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • the ignition is turned on. 2013 Navigator (nav) Owners Guide gf, 1st Printing USA (fus)