2013 Lincoln Navigator Owner Manual Printing 1 - Page 29

Child Safety 29 Follow the instructions on attaching child safety seats with tether straps. See Using Tether Straps in this chapter. Attach LATCH lower attachments of the child seat only to the anchors shown. Each time you use the safety seat, check that the seat is properly attached to the lower anchors and tether anchor, if applicable. Tug the child seat from side to side and forward and back where it is secured to the vehicle. The seat should move less than one inch when you do this for a proper installation. If the safety seat is not anchored properly, the risk of a child being injured in a crash greatly increases. Combining Safety Belt and LATCH Lower Anchors for Attaching Child Safety Seats When used in combination, either the safety belt or the LATCH lower anchors may be attached first, provided a proper installation is achieved. Attach the tether strap afterward, if included with the child seat. Using Tether Straps Many forward-facing child safety seats include a tether strap which extends from the back of the child safety seat and hooks to an anchoring point called the top tether anchor. Tether straps are available as an accessory for many older safety seats. Contact the manufacturer of your child seat for information about ordering a tether strap, or to obtain a longer tether strap if the tether strap on your safety seat does not reach the appropriate top tether anchor in the vehicle. Some of the rear seats of your vehicle are equipped with built-in tether strap anchors located behind the seats as described below. In the third row center seating position, the tether anchor is a loop at the bottom of the seatback. 2013 Navigator (nav) Owners Guide gf, 1st Printing USA (fus)