2013 Lincoln Navigator Owner Manual Printing 1 - Page 294

294 Maintenance 1. From underneath the vehicle, rotate the harness/bulb assembly counterclockwise to remove it from the fog lamp assembly. 2. Carefully disconnect the bulb from the harness assembly via the two snap clips. Install the new bulb in reverse order. Replacing Fog Lamp Bulbs Replacing Tail, Stop, Turn Signal, and Backup Lamp Bulbs The tail, stop, turn signal, and backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace any of these bulbs. 1. Make sure the headlamp switch is in the off position. 2. Open the liftgate to expose the lamp assembly screws. 3. Remove the two screws from the lamp assembly. 4. Carefully pry the lamp assembly away from the vehicle by pulling the assembly directly straight out to expose the bulb socket. DO NOT TIP THE LAMP ASSEMBLY SIDEWAYS. 5. Rotate the bulb socket counterclockwise and remove from lamp assembly. 6. Pull bulb straight out of the socket and push in the new bulb. 7. Install the bulb socket into the lamp assembly and rotate clockwise. 8. Install the lamp assembly on the vehicle and secure with two screws. 2013 Navigator (nav) Owners Guide gf, 1st Printing USA (fus)