2003 Mazda Protege Owner's Manual - Page 211
2003 Mazda Protege Manual
Page 211 highlights
J39L_EA.book Page 14 Saturday, June 8, 2002 5:35 PM Maintenance and Care Owner Maintenance Automatic transaxle 1. Remove the cooling system cap. Loosen Tighten Brake/Clutch Fluid M Inspecting Brake/Clutch Fluid Level The brakes and clutch draw fluid from the same reservoir. Inspect the fluid level in the reservoir regularly. It should be kept at MAX. The level normally drops with accumulated distance, a condition associated with wear of brake and clutch linings. If it is excessively low, have the brake/clutch system inspected by an Authorized Mazda Dealer. Tighten Loosen 2. Only when the engine is cool, remove the radiator drain plug and drain the coolant into a suitable container. 3. Flush out the system with running water. 4. Drain the system completely. Insert and tighten the plug. Add as much ethylene-glycol-based coolant and water as necessary to provide freezing and corrosion protection. 5. In extremely cold climates, add the amount recommended in the coolant manufacturer's instructions. 6. Run the engine at idle with the cooling system cap off. Slowly add additional coolant if necessary. 7. At this point, wait until the engine reaches normal operating temperature; then depress the accelerator two or three times. Add more coolant, if necessary, until the system is full. 8. Install the cooling system cap. Inspect all connections for leaks. Inspect the level in the coolant reservoir one more time. 8-14 Form No. 8Q94-EA-02G