2010 Mazda CX-7 Owner's Manual - Page 306
2010 Mazda CX-7 Manual
Page 306 highlights
CX-7_8AS7-EA-09E_Edition2 Page306 Friday, June 5 2009 2:26 PM Black plate (306,1) Interior Comfort Bluetooth Audio NOTE l l l l Always perform Bluetooth audio device programming while the vehicle is stopped. If a Bluetooth device has already been programmed to the vehicle as a hands-free mobile phone, it does not need to be programmed again when using the device as a Bluetooth audio device. Conversely, it does not need to be programmed again as a hands-free mobile phone if it has already been programmed as a Bluetooth audio device. Look around to be sure other likely Bluetooth audio devices are not in range when you start to program. If in doubt, move your car to another location. The transmission range of a Bluetooth audio device is about 10 m (32 ft). Therefore, if there is another Bluetooth audio device within a 10 m (32 ft) radius of the vehicle, the device may be identified and programmed instead. Device registration can also be done using voice recognition (page 6-76). 2. Press the audio control dial to determine the mode. After "ENTER PIN" is displayed on the information display for two seconds, "PIN 0000" is displayed and the PIN code can be input. 3. Input the PIN code of your Bluetooth audio device by pressing channel preset buttons 1 to 4 while "PIN 0000" is displayed. Press channel preset button 1 to input the first digit, 2 for the second, 3 for the third, and 4 for the forth. For example, if the PIN code were "4213", press channel preset button 1 four times (1, 2, 3, 4), button 2 twice (1, 2), button 3 once (1), and button 4 three times (1, 2, 3). If the "PIN 0000" display disappears before finishing the PIN code input, repeat the procedure from Step 1. NOTE Some devices accept only a particular pairing code (Usually, "0000" or "1234"). If pairing cannot be completed, refer to the owner's manual of your mobile device, and try those numbers if necessary. Concerning the operation of a Bluetooth audio device itself, refer to its instruction manual. Some Bluetooth audio devices have PIN codes (four digits). Refer to the audio device's instruction manual because the programming procedure differs depending on whether it has a PIN code or not. Programming a Bluetooth audio device which has a PIN code (4 digits) 1. Using the audio control dial, select the pairing program mode "PAIR DEVICE" in the "BT SETUP" mode. (Refer to "Bluetooth audio device set-up" for details.) 4. Press the audio control dial while the input PIN code is displayed. "PAIRING" flashes on the display. 5. Operate the Bluetooth audio device and set it to the program mode while "PAIRING" is flashing. 6. When the programming is completed, " " and "PAIR SUCCESS" are displayed after about 10-30 seconds, after which "PAIR SUCCESS" continues to be displayed for three seconds, and then the unit returns to the normal display. 6-66 Form No.8AS7-EA-09E