2010 Mazda CX-7 Owner's Manual - Page 307

CX-7_8AS7-EA-09E_Edition2 Page307 Friday, June 5 2009 2:26 PM Black plate (307,1) Interior Comfort Bluetooth Audio NOTE l l l l Some Bluetooth audio devices need a certain amount of time before the " " symbol is displayed. If the programming failed, "Err" flashes for three seconds. Programming cannot be performed while the vehicle is moving. If you attempt to perform programming while the vehicle is moving, "PAIR DISABLE" is displayed. If seven Bluetooth audio devices have already been programmed to the vehicle, programming cannot be performed and "MEMORY FULL" is displayed. Delete one programmed device to program another one. 6. When the programming is completed, " " and "PAIR SUCCESS" are displayed after about 10-30 seconds, after which "PAIR SUCCESS" continues to be displayed for three seconds, and then the unit returns to the normal display. NOTE l l l Programming a Bluetooth audio device which does not have a PIN code (4 digits) 1. Using the audio control dial, select the pairing program mode "PAIR DEVICE" in the "BT SETUP" mode. (Refer to "Bluetooth audio set up" for details.) 2. Press the audio control dial to determine the mode. After "ENTER PIN" is displayed on the information display for two seconds, "PIN 0000" is displayed and the PIN code can be input. 3. Press the audio control dial while "PIN 0000" is displayed. "PAIRING" flashes on the display. 4. Operate the Bluetooth audio device and set it to the program mode while "PAIRING" is flashing. 5. As the Bluetooth audio device requires a PIN code, input "0000". l l If pairing cannot be completed, try "1234" instead. Refer to the owner's manual of your mobile device for the right PIN code. Some Bluetooth audio devices need a certain amount of time before the " " symbol is displayed. If the programming failed, "Err" flashes for three seconds. Programming cannot be performed while the vehicle is moving. If you attempt to perform programming while the vehicle is moving, "PAIR DISABLE" is displayed. If seven Bluetooth audio devices have already been programmed to the vehicle, programming cannot be performed and "MEMORY FULL" is displayed. Delete one programmed device to program another one. Changing the link to a Bluetooth audio device If several devices have been programmed, the Bluetooth unit links the device last programmed. If you would like to link a different programmed device, it is necessary to change the link. The order of device priority after the link has been changed is maintained even when the ignition switch is turned off. 1. Using the audio control dial, select the link change mode "LINK CHANGE" in the "BT SETUP" mode. (Refer to "Bluetooth audio device set-up" for details.) 6-67 Form No.8AS7-EA-09E