1996 Mercury Villager Owner Guide 1st Printing - Page 207

Electronic Sound Systems s Using the "TUNE" button to select the tune function You can change the frequency up or down one increment at a time (FM changes in increments of 200 kHz; AM changes in increments of 10 kHz) by pressing the "TUNE" button. To change frequencies quickly, press and hold down either the right or left side of the "TUNE" button. Manual tuning adjusts your radio to any allowable broadcast frequency, whether or not a station is present on that frequency. (See All About Radio Frequencies later in this chapter.) s Using the "SEEK" function This feature on your radio allows you to automatically select listenable stations up or down the frequency band. Press the right (a) side of the "SEEK" button to select the next listenable station up the frequency band. Press the left (b) side of the button to select the next listenable station down the frequency band. By holding the button down, listenable stations can be passed over to reach the desired station. s Using the "SCAN" button to scan radio stations Pressing the "SCAN" button once enters the scan mode by stopping on each listenable station for a five-second sampling. The radio band (AM/FM1/FM2) will blink to indicate that the radio is scanning. To stop the scan mode on the presently sampled station press the "SCAN" button again. Setting the station memory preset buttons Your radio is equipped with 6 station memory buttons. These buttons can be used to select up to 6 preset AM stations and 12 FM stations (6 in FM1 and 6 in FM2). Follow the easy steps below to set these buttons to the desired frequencies: 1. Select a band, then select a frequency. 211