1996 Mercury Villager Owner Guide 1st Printing - Page 62
1996 Mercury Villager Manual
Page 62 highlights
3. Make sure that the gearshift is in P (Park) and the parking brake is set before you turn the key. 4. Test the warning lights on the instrument cluster to make sure they work. Refer to the Warning Lights and Gauges chapter. Starting Your Engine To start your engine: 1. Follow the steps under Preparing to Start Your Vehicle at the beginning of this section. 2. Keep your foot on the brake pedal and turn the ignition key to ON. 3. DO NOT depress the accelerator pedal when starting your engine. DO NOT use the accelerator while the vehicle is parked. 4. Turn the key to the START position (cranking) until the engine starts. Allow the key to return to the ON position after the engine has started. If you have difficulty in turning the key, rotate the steering wheel slightly because it may be binding. For a cold engine: s At temperatures 10˚F (-12˚C) and below: If the engine does not start in fifteen (15) seconds on the first try, turn the key to OFF, wait approximately ten (10) seconds so you do not flood the engine, then try again. s At temperatures above 10˚F (-12˚C): If the engine does not start in five (5) seconds on the first try, turn the key to OFF, wait approximately ten (10) seconds so you do not flood the engine, then try again. 60