2002 Mercury Villager Owner's Manual - Page 135

Seating and Safety Restraints Safety belt warning light and indicator chime The seat belt warning light illuminates in the instrument cluster and a chime sounds to remind the occupants to fasten their safety belts. Conditions of operation If...The driver's safety belt is not buckled before the ignition switch is turned to the ON position...The driver's safety belt is buckled while the indicator light is illuminated and the warning chime is sounding...The driver's safety belt is buckled before the ignition switch is turned to the ON position...Then...The safety belt warning light illuminates until safety belt is buckled. The safety belt warning light and warning chime turn off. The safety belt warning light and indicator chime remain off. Safety belt extension assembly If the safety belt is too short when fully extended, there is a 20 cm (8 inch) safety belt extension assembly that can be added (part number 611C22). This assembly can be obtained from your dealer at no cost. Use only extensions manufactured by the same supplier as the safety belt. Manufacturer identification is located at the end of the webbing on the label. Also, use the safety belt extension only if the safety belt is too short for you when fully extended. Do not use extensions to change the fit of the shoulder belt across the torso. Safety belt maintenance Inspect the safety belt systems periodically to make sure they work properly and are not damaged. Inspect the safety belts to make sure there are no nicks, tears or cuts, replacing if necessary. All safety belt assemblies, including retractors, buckles, front seat belt buckle assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt height adjusters (if equipped), shoulder belt guide on seatback (if equipped), LATCH child safety seat tether anchors and lower anchors, 135