2002 Mercury Villager Owner's Manual - Page 99
2002 Mercury Villager Manual
Page 99 highlights
Driver Controls Erasing HomeLink buttons To erase the three programmed buttons (individual buttons cannot be erased): • Press and hold the two outer HomeLink buttons until the red indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with step 2 in the "Programming" section. Reprogramming a single HomeLink button To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. Do NOT release the button. 2. The red indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, follow step 2 in the "Programming" section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. ELECTRONIC MESSAGE CENTER (IF EQUIPPED) The electronic message center only works when the ignition is in the ON position. The message center allows you to: • display the outside temperature. • change your gauges from English ˚F ˚C to metric units. MILES/GAL L/100 km MILES km • monitor the instantaneous fuel OUTSIDE TEMP economy. INST ECONOMY AVG ECONOMY • monitor the average fuel TO EMPTY economy. • see how many kilometers/miles you can drive before running out of fuel. 99