2007 Mercury Milan Owner Guide 1st Printing - Page 57
2007 Mercury Milan Manual
Page 57 highlights
Lights 5. Remove screw from oval splash shield access panel from the exterior wheel well area. Lift up and rearward to release a hidden finger attachment at the lower portion of the panel (Passenger side only with ABS). 6. From the exterior wheel well area reach arm through splash shield opening to access bulb socket (Passenger side only with ABS). 7. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 8. Let go of the bulb socket and let the bulb socket dangle downward near the lamp housing (Passenger side only with ABS). 9. Reach over the front bolster in the engine area, with a tool if necessary, bring the bulb socket upwards into an unobstructed area to replace the bulb (Passenger side only with ABS). 10. Carefully pull bulb straight out of socket and push in the new one. 11. After the new bulb is installed, carefully let the bulb socket dangle downward near the lamp housing (Passenger side only with ABS). 12. From the exterior wheel well area reach arm through splash shield opening to install bulb socket with new bulb (Passenger side only with ABS). 13. Install new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to locked position. 14. Reinstall the AirTube to the air filter assembly. (Driver's side only). 15. Reinstall the vertical shield to the bolster. (Driver's side only). 16. Reinstall the splash shield access panel with screw. (Passenger side only with ABS). 57 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)