2000 Nissan Xterra Owner's Manual - Page 162
2000 Nissan Xterra Manual
Page 162 highlights
CAUTION Always connect positive (+) to positive (+) and negative (−) to body ground (for example, engine lift bracket, etc.) - not to the battery. Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal. ACE1018 5. Start the engine of the booster vehicle and let it run for a few minutes. 6. Keep the engine speed of the booster vehicle at about 2,000 r/min, and start the engine of the vehicle being jump started. CAUTION Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the key off and wait 3 to 4 seconds before trying again. 7. After starting your engine, carefully disconnect the negative cable and then the positive cable. In case of emergency 6-9 Do not attempt to jump start a frozen battery. It could explode and cause serious injury. WARNING Always follow the instructions below. Failure to do so could result in damage to the charging system and cause personal injury. 1. If the booster battery is in another vehicle, position the two vehicles to bring their batteries into close proximity to each other. Do not allow the two vehicles to touch. 2. Apply the parking brake. Move the shift selector lever to N (Neutral) (on automatic transmission models, move the lever to P (Park)). Switch off all unnecessary electrical systems (lights, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with an old cloth to reduce explosion hazard. 4. Connect jumper cables in the sequence as illustrated.