2012 Nissan Rogue Owner's Manual - Page 128
2012 Nissan Rogue Manual
Page 128 highlights
HomeLink® button you've just programmed. Push and release the HomeLink® button up to three times to complete the training. 8. Your HomeLink® button should now be programmed. To program the remaining HomeLink® buttons for additional door or gate openers, follow steps 2 through 8 only. NOTE: Do not repeat step 1 unless you want to "clear" all previously programmed HomeLink® buttons. If you have any questions or are having difficulty programming your HomeLink® buttons, please refer to the HomeLink® web site at: www. homelink.com or call 1-800-355-3515. NOTE: If programming a garage door opener, etc., it is advised to unplug the device during the "cycling" process to prevent possible damage to the garage door opener components. HomeLink® Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. The red indicator light will illuminate while the signal is being transmitted. OPERATING THE HomeLink® UNIVERSAL TRANSCEIVER S35-D-110201-2F4ADB5B-DB01-458A-B276-C4210429C7AD surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner's Manual. CLEARING THE PROGRAMMED INFORMATION S35-D-110201-27C5AE41-4F1F-4D07-8C90-BF387497020E Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds). PROGRAMMING HomeLink FOR CANADIAN CUSTOMERS GUID-6ACFA63C-38E7-40AC-9D44-7085C554AF73 Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under "Programming HomeLink®") while you push and re-push ("cycle") your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming). ® PROGRAMMING TROUBLE-DIAGNOSIS S35-D-110201-0B7FA6ED-FEC7-47F2-8980-375FA4DA8824 If HomeLink® does not quickly learn the handheld transmitter information: . . replace the hand-held transmitter batteries with new batteries. position the hand-held transmitter with its battery area facing away from the HomeLink® surface. push and hold both the HomeLink® and hand-held transmitter buttons without interruption. position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink ® button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. REPROGRAMMING A SINGLE ® HomeLink BUTTON S35-D-110201-6CBBA29C-5D44-408B-8B3F-6BE900E6D619 . . 2-58 Instruments and controls