2012 Nissan Rogue Owner's Manual - Page 46
2012 Nissan Rogue Manual
Page 46 highlights
seat belt is not locked, repeat steps 1 through 6. After the child restraint is removed and the seat belt fully retracted, the ALR mode (child restraint mode) is canceled. FORWARD-FACING CHILD RESTRAINT INSTALLATION USING LATCH GUID-485A2C23-22CE-47D8-A4B0-982AC225E511 Refer to all Warnings and Cautions in the "Child safety" and "Child restraints" sections before installing a child restraint. SSS0657 Rear-facing - step 5 Rear-facing - step 6 SSS0658 Follow these steps to install a forward-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restraint manufacturer's instructions. 5. Remove any additional slack from the seat belt; press downward and rearward firmly in the center of the child restraint to compress the vehicle seat cushion and seatback while pulling up on the seat belt. 6. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the seat belt path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the belt holds the restraint in place. If the restraint is not secure, tighten the seat belt as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint. Not all child restraints fit in all types of vehicles. 7. Check to make sure that the child restraint is properly secured prior to each use. If the 1-30 Safety - Seats, seat belts and supplemental restraint system