2012 Nissan Rogue Owner's Manual - Page 231
2012 Nissan Rogue Manual
Page 231 highlights
GETTING STARTED S35-D-110201-363B3716-4171-4E1D-92BB-B6C8C2F728AD The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to "List of voice commands" later in this section. NOTE: You must push the button or the button within 5 seconds to change the language. Current language English Spanish French Push (TALK/ Push (MODE/ PHONE SEND) PHONE END) to select to select Spanish English English French French Spanish Choosing a language S35-D-110201-9ED1490B-F9A5-48AB-ADF8-DA6C6BE9BBA1 You can interact with the Bluetooth® HandsFree Phone System using English, Spanish or French. To change the language, perform the following. SAA1782 1. Push and hold the 5 seconds. button for more than CONTROL BUTTONS S35-D-110201-703550E9-3DE2-433E-AB80-CD46939E5B53 The control buttons for the Bluetooth® HandsFree Phone System are located on the steering wheel. PHONE SEND Push the button to initiate a VR session or answer an incoming call. You can also use the button to interrupt system feedback and give a command at once. PHONE END While the voice recognition system is active, push the button to go back one step. Push and hold the button for 5 seconds to quit the voice recognition system at any time. 2. The system announces: "Push the PHONE SEND ( ) button for the hands-free phone system to enter the speaker adaptation mode or push the PHONE END ( ) button to select a different language." 3. Push the button. For information on speaker adaptation, see "Speaker Adaptation (SA) mode" later in this section. 4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). Use the following chart to select the language. 5. If you decide not to change the language, do not push either button. After 5 seconds, the VR session will end, and the language will not be changed. Connecting procedure S35-D-110201-70B0342B-394D-4E2C-ACD1-017AECE46CD1 NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. NOS2623 Center display, heater, air conditioner, audio, phone and voice recognition systems 4-71