2013 Nissan Rogue Owner's Manual - Page 105

Battery saver system GUID-C87E6811-F73E-43C4-B263-0CDDFD967519 . When the headlight switch is in the or position while the ignition switch is in the ON position, the lights will automatically turn off within a period of time after the ignition switch has been turned to the OFF position. When the headlight switch remains in the or position after the lights automatically turn off, the lights will turn on when the ignition switch is turned to the ON position. SIC2275 WARNING Xenon headlights are extremely bright compared to conventional headlights. If the xenon headlights hit the rearview mirror of the vehicle ahead or the windshield of oncoming vehicle, the driver of these vehicles may have difficulty driving because of the brightness. Use the headlight aiming control switch to lower the light axis. See "Xenon headlights" earlier in this section for additional information. . CAUTION . When you turn on the headlight switch again after the lights automatically turn off, the lights will not turn off automatically. Be sure to turn the light switch to the OFF position when you leave the vehicle for extended periods of time, otherwise the battery will be discharged. Never leave the light switch on when the engine is not running for extended periods of time even if the headlights turn off automatically. Headlight aiming control (if so equipped) S35-D-110201-1FB40E63-F262-4574-B0B3-682A946243B6 Depending on the number of occupants in the vehicle and the load it is carrying, the headlight axis may be higher than desired. If the vehicle is traveling on a hilly road, the headlights may directly hit the rearview mirror of the vehicle ahead or the windshield of the oncoming vehicle. The light axis can be lowered with the operation of the switch. The larger the number designated on the switch, the lower the axis. When traveling with no heavy load or on a flat road, select position 0. Daytime running light system (Canada only) GUID-10297789-CB0E-4316-8D06-E96C4D5A3D58 The daytime running lights automatically illuminate when the engine is started with the parking brake released. The daytime running lights operate with the headlight switch in the OFF position or in the position. Turn the headlight switch to the position for full illumination when driving at night. If the parking brake is applied before the engine is started, the daytime running lights do not illuminate. The daytime running lights illuminate once the parking brake is released. The daytime running lights will remain on until the ignition Instruments and controls 2-33 .