2013 Nissan Rogue Owner's Manual - Page 276
2013 Nissan Rogue Manual
Page 276 highlights
2. Apply the parking brake. Move the selector lever to the P (Park) position. Switch off all unnecessary electrical systems (lights, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with a firmly wrung out moist cloth to reduce explosion hazard. 4. Connect jumper cables in the sequence as 1 ? * 2 ? * 3 ? * 4 ). illustrated (* For the vehicle equipped with Intelligent Key system: SCE0707 metal. 5. Start the engine of the booster vehicle and let it run for a few minutes. B * 6. Keep the engine speed of the booster B at about 2,000 rpm, and start vehicle * A being jump the engine of the vehicle * started. CAUTION Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the ignition switch to the OFF position and wait 10 seconds before trying again. 7. After starting your engine, carefully disconnect the negative cable and then the positive 4 ? * 3 ? * 2 ? * 1 ). cable (* 8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid. WARNING Always follow the instructions below. Failure to do so could result in damage to the charging system and cause personal injury. . 1. If the booster battery is in another vehicle B , position the two vehicles (* A and * B ) * to bring their batteries into close proximity to each other. Do not allow the two vehicles to touch. If the battery is discharged, the ignition switch cannot be moved from the LOCK position. Connect the jumper cables to B before turning the booster vehicle * the ignition switch. CAUTION Always connect positive (+) to positive (+) and negative (−) to body ground (for example, as illustrated), not to the battery. Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other . 6-10 In case of emergency