2013 Nissan Rogue Owner's Manual - Page 86
2013 Nissan Rogue Manual
Page 86 highlights
off. Front passenger air bag status light S35-D-110201-CE599749-7443-4418-9473-AB9574042550 The front passenger air bag status light will be lit and the passenger front air bag will be OFF depending on how the front passenger seat is being used. For front passenger air bag status light operation, see "NISSAN Advanced Air Bag System (front seats)" in the "1. Safety - Seats, seat belts and supplemental restraint system" section of this manual. After a few driving trips, the light should turn off if no other potential emission control system malfunction exists. If this indicator light remains on for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/ maintenance test. (See "Readiness for Inspection/Maintenance (I/M) test" in the "9. Technical and consumer information" section.) Operation: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 The malfunction indicator light will illuminate in one of two ways: . Malfunction indicator light illuminated steady - An emission control system and/or CVT malfunction has been detected. Check the fuel-filler cap if the LOOSE FUEL CAP warning appears in the vehicle information display. If the fuel-filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. The light should turn off after a few driving trips. If the light does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. Malfunction indicator light blinking - An engine misfire has been detected which may damage the emission control system. High beam indicator light S35-D-110201-07BD5427-AE0D-485E-80A5-812FA0319F8E This light illuminates when the headlight high beam is on and goes out when the low beam is selected. To reduce or avoid emission control system damage: - Do not drive at speeds above 45 MPH (72 km/h). - Avoid hard acceleration or deceleration. - Avoid steep uphill grades. - If possible, reduce the amount of cargo being hauled or towed. The malfunction indicator light may stop blinking and remain illuminated. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. CAUTION Continued vehicle operation without having the emission control system and/or CVT system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Malfunction Indicator Light (MIL) S35-D-110201-F2AAEA88-0C31-456F-B0D1-06BE0BA285F5 If the malfunction indicator light illuminates steady or blinks while the engine is running, it may indicate a potential emission control and/or Continuously Variable Transmission (CVT) malfunction. The malfunction indicator light may also illuminate steady if the fuel-filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 US gallons (11.4 liters) of fuel in the fuel tank. . 2-14 Instruments and controls