2013 Nissan Rogue Owner's Manual - Page 108
2013 Nissan Rogue Manual
Page 108 highlights
VEHICLE DYNAMIC CONTROL (VDC) OFF SWITCH S35-D-110201-A6E4B20D-7614-4546-90DD-DBDB4900E03B The heater is controlled by a thermostat, automatically turning the heater on and off. The indicator light will remain on as long as the switch is on. When the vehicle's interior is warmed, or before you leave the vehicle, be sure to turn off the switch. SIC3355 SSD1153 The front seats are warmed by built-in heaters. The switches located on the center console can be operated independently of each other. 1. Start the engine. 2. Select heat range. 1 For high heat, push the HI (High) side of * The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine power is needed to free a stuck vehicle, turn the VDC system off. To turn off the VDC system, push the VDC OFF switch. The indicator will illuminate. Push the VDC OFF switch again or restart the engine to turn on the system. (See "Vehicle Dynamic Control (VDC) system" in the "5. Starting and driving" section.) the switch. the switch. 2 For low heat, push the LO (Low) side of * 3 The indicator light in the switch * will illuminate when low or high is selected. 3. To turn off the heater, return the switch to the level position. Make sure the indicator light goes off. 2-36 Instruments and controls