2013 Nissan Rogue Owner's Manual - Page 355
2013 Nissan Rogue Manual
Page 355 highlights
Sway control device GUID-CA43C3C2-6AFA-4A0F-945D-1C0EEDB8B5F8 Sudden maneuvers, wind gusts and buffeting caused by other vehicles can affect trailer handling. Sway control devices may be used to help control these affects. If you choose to use one, contact a reputable trailer hitch supplier to make sure the sway control device will work with the vehicle, hitch, trailer and the trailer's brake system. Follow the instructions provided by the manufacturer for installing and using the sway control device. struck from the rear, where practical, remove the hitch and/or receiver when not in use. After the hitch is removed, seal the bolt holes to prevent exhaust fumes, water or dust from entering the passenger compartment. . Regularly check that all trailer hitch mounting bolts are securely mounted. turning corners. Trailer lights GUID-A29FE40B-6D31-4369-84A4-A3AB91FE8E44 CAUTION When splicing into the vehicle electrical system, a commercially available power-type module/converter must be used to provide power for all trailer lighting. This unit uses the vehicle battery as a direct power source for all trailer lights while using the vehicle tail light, stoplight and turn signal circuits as a signal source. The module/converter must draw no more than 15 milliamps from the stop and tail lamp circuits. Using a module/converter that exceeds these power requirements may damage the vehicle's electrical system. See a reputable trailer dealer to obtain the proper equipment and to have it installed. Trailer lights should comply with federal and/or local regulations. For assistance in hooking up trailer lights, contact a NISSAN dealer or reputable trailer dealer. Class I hitchGUID-8755D6BA-3FF5-44C8-AAA8-87A25DC7A9B5 Class I trailer hitch equipment (receiver, ball mount and hitch ball) can be used to tow trailers of a maximum weight of 2,000 lb (909 kg). Tire pressures GUID-24AC9370-4921-4DCC-A994-22A3A4903D8D . When towing a trailer, inflate the vehicle tires to the recommended cold tire pressure indicated on the Tire and Loading Information label. Trailer tire condition, size, load rating and proper inflation pressure should be in accordance with the trailer and tire manufacturers' specifications. CAUTION . The hitch should not be attached to or affect the operation of the impact-absorbing bumper. Do not use axle-mounted hitches. Do not modify the vehicle exhaust system, brake system, etc. to install a trailer hitch. To reduce the possibility of additional damage if your vehicle is . Safety chains GUID-C6AFFF2D-3488-4102-BC8F-7EB7C5A9DF69 Always use a suitable chain between your vehicle and the trailer. The safety chains should be crossed and should be attached to the hitch, not to the vehicle bumper or axle. The safety chains can be attached to the bumper if the hitch ball is mounted to the bumper. Be sure to leave enough slack in the chains to permit . . . Technical and consumer information 9-21