2013 Nissan Rogue Owner's Manual - Page 120

Auto reverse function S35-D-110201-AF18E966-5C54-4980-BC51-E872555FB4DF If the moonroof does not operate GUID-750E5F7D-B6E5-4E9E-9714-1DE514A949D8 If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system. 1. If the moonroof is open, close it fully by repeatedly pushing the switch toward 2 . * 2. Push and hold the switch toward tilt the moonroof up. 2 to * WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof. If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened. The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is turned to the OFF position. If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the switch toward 2 . * Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. 3. Release the moonroof switch after the moonroof moves slightly up and down. 4. Push and hold the switch toward fully tilt the moonroof down. 1 to * SIC3510 Sliding the moonroof GUID-E58CB540-F94C-4392-847D-DF07AA0A152B To fully open or close the moonroof, push the 1 or 2 and release switch toward * * it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch in any direction while it is opening or closing. 5. Check if the moonroof switch operates normally. If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer. Tilting the moonroof GUID-F8514024-28D3-4F20-A4B9-9C5D9274A6BB To tilt up, first close the moonroof by pushing the 2 . Push the switch toward switch toward * 2 again and release it; it need not be * held. To tilt down the moonroof, push the switch 1 . toward * 2-48 Instruments and controls