2013 Nissan Rogue Owner's Manual - Page 255

ALL-WHEEL DRIVE (AWD) (if so equipped) S35-D-110201-720F0BC2-3B55-4DBD-B301-E1E82EFAD720 Keep the sonar sensors (located on the bumper fascia) free from snow, ice and large accumulations of dirt (do not clean the sensors with sharp objects). If the sensors are covered, it will affect the accuracy of the sonar system. If the sonar system malfunctions, the beep sounds for 3 seconds when the ignition switch is placed in the ON position. Have the system checked by a NISSAN dealer. WARNING . For AWD equipped vehicles, do not attempt to raise two wheels off the ground and shift the transmission to any drive or reverse position with the engine running. Doing so may result in drivetrain damage or unexpected vehicle movement which could result in serious vehicle damage or personal injury. Do not attempt to test an AWD equipped vehicle on a 2-wheel dynamometer (such as the dynamometers used by some states for emissions testing) or similar equipment even if the other two wheels are raised off the ground. Make sure that you inform the test facility personnel that your vehicle is equipped with AWD before it is placed on a dynamometer. Using the wrong test equipment may result in drivetrain damage or unexpected vehicle movement which could result in serious vehicle damage or personal injury. SSD0418 . ALL-WHEEL DRIVE (AWD) LOCK SWITCH OPERATIONS S35-D-110201-E7D4937A-2081-4CEB-9B79-163753F74E25 The AWD LOCK switch located on the lower side of the instrument panel. This switch is used to select the AUTO or LOCK mode depending on the driving conditions. Each time you push the lower part of the switch A , the AWD mode will switch: * AUTO ? LOCK ? AUTO. Starting and driving 5-23