1998 Oldsmobile Cutlass Owner's Manual - Page 94
1998 Oldsmobile Cutlass Manual
Page 94 highlights
Turn and Lane Change Signals If a bulbis burned out, replaceit to help avoid an accident. If the arrow doesn't go on at all when you The turn signal has two upward (for right) and two signal aturn, check for burned-out bulbs and then check downward (forleft) positions. These positions allow you the fuse (see "Fuses and Circuit Breakers" Index). in the to signal a turn or a lane change. To signal a turn, move the lever all the way up or down. un will When thet r is finished, the lever return automatically. An arrow on the instrument panel will flash the in direction of the turn or lane change. Headlamp HighLow Beam To change the headlamps . from low beam to high beam, push forward on the turn signal/multifunction lever. I I To signal a lane change, raise or lower the lever just until the arrow starts flash. Hold it there until you to complete your lane change. The lever will return by itself when you release it. A warning chime signal will come onyou haveleft if 3/4 your turn signal on for more than mile (1 km). As you signal a turn or a lane change, if the arrow flashes rapidly, a signal bulb may be burned and out other drivers won't see your turn signal. To change the headlamps fkom high beam to low beam, un the pull thet r signal lever backward. When high the beams are on, a light on instrument panel will also be on. Flash to Pass This feature lets you use your high-beam headlamps to pass. signal a driver in frontyou that you want to of To use it, pull the turn signal/multifunction lever toward you until the high-beam headlamps come then on, off. release the lever to turn them