2010 Polaris Ranger EV Owners Manual - Page 35
2010 Polaris Ranger EV Manual
Page 35 highlights
Malfunction Indicator Troubleshooting Guide FEATURES AND CONTROLS The malfunction codes will blink on the controller. The code definitions provided here are for informational purposes only. Tip: If the indicator illuminates due to a minor issue such as a low voltage condition or a sequence fault (reversing direction without releasing the accelerator, turning the key on while in forward or reverse), select neutral and turn the key off and on to clear the error. If the error does not clear, please see your Polaris dealer for diagnosis and repair. # of Blinks Steady 1 2 3 4 6 7 8 13 Code Definition Key was turned on in forward or reverse (switch to neutral, then to forward or reverse) Data or configuration error Sequence fault Power fault Contactor issue Throttle input error Voltage protection Controller or motor out of temperature range Software fault Charge Status Indicator Troubleshooting Guide The code definitions provided are for informational purposes only. Please see your Polaris dealer for diagnosis and repair. # of Blinks 1 2 3 Code Definition Battery high voltage Battery low voltage Charge time-out, battery pack not reaching required voltage, charger output reduced due to high temperatures Battery could not be tricklecharged to minimum voltage Charger shut down due to overheating Charger internal fault Solution Check battery size and condition; reset charger (interrupt AC power for 15 seconds) Check connections; operate charger at lower ambient temperature Check battery for shorted or damaged cells Ensure sufficient cooling air flow (open the hood) and reset the charger (interrupt AC power for 15 seconds) Reset charger (interrupt AC power for 15 seconds); return to qualified service provider if fault persists 4 5 6 31