1995 Pontiac Firebird Owner's Manual - Page 290

- + If a ring forms after spot cleaning, clean entire the area immediately or it will set. NOTICE: Be careful. A blow dryer may scorch the fabric. 0 Using Foam-Type Cleaner on Fabric 0 0 Vacuum and brush the area to remove any loose dirt. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. Use suds only and apply with a clean sponge. Don't saturate the material. Don't rubit roughly. As soon asyou've cleaned the section, use a sponge to remove the suds. Wipe with a clean cloth. Using Solvent-Type Cleaner on Fabric First, seeif you have to use solvent-type cleaner at all. off Some spots and stains will clean better withjust water and mild soap. If you need to use a solvent: 0 0 0 0 0 0 0 Rinse the section with a clean, wet sponge. Wipe off what's left with a slightly damp paper towel or cloth. Then dryit immediately with a blow dryer or a heat lamp. 0 0 Gently scrape excess soil from the trim material with a clean,dull knife or scraper. Use verylittle cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start at outside of the the stain, "feathering" toward the center. Keep changing to a clean section the cloth. of When you clean a stain from fabric, immediately dry the area with a blow dryer to help prevent a cleaning ring. (See the previous NOTICE.) 0 6-57