2003 Pontiac Sunfire Owner's Manual - Page 152

Finding a Station BAND: Press this button to switch between AM, FMI, FM2, or XMI, XM2 (USA only, if equipped). The display will show your selection. TUNE: Turn this knob to choose ,radjo, ~tatjons~. Setting Preset Stations The six numbered pushbuttons let you return to your favorite stations. You can set up to 30 stations (six AM, six FMI and six FM2, six XM1 and six XM2 (USA only, if equipped), by performing the following steps: 1. Turn the radio on. 2. Press BAND to select AM, FMl, FM2, or XMI, or XM2. A SEEK : Press the up or the down arrow to go to the next or to the previous station and stay there. The radio will seek only to stations that are in the selected band and only to those with a strong signal. v 3. Tune in the desired station. 4. Press EQ to select the equalization. 5. Press and hold one of the six numbered pushbuttons until you hear a beep. Whenever you press that numbered pushbutton, the station you set will return and the equalization that you selected will also be automatically selected for that pushbutton. 6. Repeat the steps for each pushbutton. SCAN : Press and hold one of the SCAN arrows for two seconds until SCAN appears on the display and you hear a beep. The radio will go to a station, play for a few seconds, then go on to the next station. Press one of the SCAN arrows again to stop scanning. To scan preset stations, press and hold one of the SCAN arrows for more than four seconds until PSCAN and the preset number appear on the dlsplay. You will hear a double beep. The radio will go to the first preset station stored on your pushbuttons, play for a few seconds, then go on to the pext preset station. Press one of the SCAN arrows again to stop scanning presets. The radio will scan only to statians that are in the selected band and only to those with a strong signal. v 3-45