Aastra DT423 User Guide - Cordless Phones for MX-ONE - Page 89
LED Error Indications
View all Aastra DT423 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
User Manual Cordless Phones for MX-ONE™ SERVICE NEEDED Invalid IPDI Note: This display message is only shown in English. Easy replacement procedure not Send the handset for service. followed correctly or failure during easy replacement procedure. SERVICE NEEDED Parameters corrupt. Note: This display message is only shown in English. The handset is defective. Select reset option on the middle soft key if available or if no reset option is available or fault does not resolve the handset needs repair. Note: Display message only shown in English. Enter PIN code The handset's lock is activated. Enter the required PIN code. If PIN code lost enter new via PDM or do a factory reset via PDM. Battery low, charge now The battery level is low. Charge or replace the battery. Phonebook is not The phonebook does not respond, Try again later or if fault persists available at the moment. not available at the moment. do a factory reset via admin menu or PDM. Voice mail number not There is no Voice mail number defined defined in the handset. Define a Voice mail number via PDM. Could not encrypt connection The parameter "Encryption 1) Disable the "Encryption Required" is enabled in the handset required" parameter in handset in combination with; via PDM; and/or, 1) Unencrypted base station(s); and/ or, 2) Enable the encryption in the base station(s); and/or, 2) Unsupported base station(s). 3) Use supported base station(s). Ask your supplier. Not allowed 2) The extension (User) does not exists. 3) The password is not correct. 2) Make sure that you entered correct extension. If needed, contact the system administrator. 3) Make sure that you have entered correct password. Ask the system administrator if you have forgot the password. LED Error Indications See also chapter LED Indications during Easy Replacement on page 79. LED is flashing red, quick flash, (100 ms on, 800 ms off) 1) If a third handset, that is another handset than the "old" (the replaced handset) and "new" (the replacement handset) handset, is inserted into the charger during Easy Replacement, this error indication appears. Change to the correct handset. 2) The charger has found that Easy Replacement does not work. Change back to the "new" handset. LED is flashing red, long flash (800 ms on, 100 ms off) Error during Easy Replacement. Both handsets need to be sent for service. 1424-EN/LZT 103 089 B 2014-04-13 83